Programming The System - marposs E86N Manuel D'installation Et D'utilisation

10. PROGRAMMING THE SYSTEM

Hold down the "Enter" key for longer than 2 seconds to switch the system to programming mode. Then select the type of programming
with the "Select" key:
I --> Interface Programming
P --> Transmitter Programming
r --> Transmitter Programming in "Recovery" mode
rSS Programming the "Sniffer" function
When you have made your selection, use the "Select" and "Enter" keys to edit the programming data. The "Select" key increases the
current programming data item, whilst the "Enter" key confirms it and goes to the next item.
> 2 seconds
CAUTION: If you want to reprogram only the Operating channel, start the procedure from transmitter programming.
In this way, since the interface is supplied with the Automatic channel programming function enabled (AP=1 – see sec.
10.1 "Programming the interface" on page 72) when transmitter operating channel reprogramming is complete, the
interface is also automatically programmed on the same channel.
mida
TRANSMITTER
INTERFACE
PROGRAMMING
PROGRAMMING
TRANSMITTER
PROGRAMMING IN
RECOVERY MODE
PROGRAMMING THE
"SNIFFER" FUNCTION
71