Configuration And Operation - marposs E86N Manuel D'installation Et D'utilisation

3. CONFIGURATION AND OPERATION

The touch system with radio transmission identifies points in space which are processed by the machine tool CNC to provide
measurements. These points are detected by the probe, a precision multi-directional microswitch, and sent by the radio transmission
system, consisting of a transmitter and a receiver, to the interface unit, which adapts them for use by the CNC. The measuring cycle
retrieves the probe/transmitter unit mounted on the tool taper from the tool magazine and inserts it in the spindle. The system is easy to
use and is designed to operate in the most hostile industrial environments. It is used on machining centres and milling machines for:
identifying, positioning and measuring the part to be machined and measuring the part after machining.
System typical application:
A - Part to be measured
B - Finger
C - Touch probe
D - E86N transmitter
G
Figure 3-1. Configuration and operation.
mida
E - Machine tool spindle
F - E86N antenna
G - E86N interface unit
H - Machine tool CNC
F
H
E
D
C
B
A
55