Programming The Transmitter In Recovery Mode - marposs E86N Manuel D'installation Et D'utilisation

10.3

Programming the transmitter in Recovery mode

If the transmitter is in one of the following conditions:
d. unknown transmitter transmission channel
e. transmission channel incorrectly programmed (e.g.: 65-69 or 00)
f. identification code incorrectly programmed (different to that of the interface)
the transmitter "recovery" programming procedure is required, which allows you to view and if necessary change transmitter
parameters.
Recovery procedure:
7. Leaving the interface powered up, power down the transmitter (unscrew the battery cover for the transmitter with radio
activation or open the microswitch on the taper for the transmitter with mechanical activation).
8. From the interface switch to programming mode and select programming type "r".
9. Press <ENTER> on the display and the "REC" message appears.
10. Deflect the finger and hold it there while you power up the transmitter (close the battery cover for the transmitter with radio
activation or close the microswitch on the taper for the transmitter with mechanical activation).
11. The transmitter is activated on a service channel rather than on the programmed channel and the "REC" message is cleared
from the interface display, which instead shows the channel number (with the tens flashing) on which the transmitter was
programmed.
12. Release the finger, keeping the transmitter powered up (cover closed/microswitch on taper closed).
When you have obtained the required information, you can
•
exit the programming mode
holding down the <ENTER> key for longer than 2 seconds or by simply releasing the cover/microswitch
•
perform a normal transmitter programming procedure as described in sec. 10.2 "Programming the Transmitter" on page 75.
CAUTION: If "Automatic channel programming" is enabled in the interface (AP=1 – see sec. 10.1 "Programming the
interface"), when transmitter programming is complete, the interface channel also changes, so that it is the
same as that on the transmitter.
mida
> 2 seconds
PROGRAMMING THE
TRANSMITTER
(see sec. 10.2)
77