Connecting Diagram; Connecting The Drive Motors; Connecting The Battery - Truma Mover XT Instructions De Montage

Connecting diagram

Installation in front of axle
E
1 3
B A
+ - - +
+
-
C
Figure 30
Installation behind axle
E
1 3
A
B
+ - - +
+
-
C
Figure 31
Once the cables have been routed out of the control unit, they
must be strain-relieved.
EN
28
B
D
5 7 9
M6 = 6 Nm
M5 = 3.5 Nm
A
D
5 7 9
M6 = 6 Nm
M5 = 3.5 Nm
PIN Description
(Fig. 30 / 31)
Battery (C)
Battery + Battery + terminal, red 16 mm2
Battery - Battery - terminal, black 16 mm2
Drive assemblies in front of the axle
Motor left + (B) Motor left + terminal, red 10 mm2
Motor left - (B) Motor left - terminal, black 10 mm2
A
Motor right + (A) Motor right + terminal, red 10 mm2
Motor right - (A) Motor right - terminal, black 10 mm2
Drive assemblies behind the axle
Motor left + (A) Motor left + terminal, red 10 mm2
Motor left - (A) Motor left - terminal, black 10 mm2
Motor right + (B) Motor right + terminal, red 10 mm2
Motor right - (B) Motor right - terminal, black 10 mm2
Connector block (D)
K1-1 Safety socket, black
K1-2 Safety socket, black / red
K1-3 Data cable motor left, black 0.5 mm2
K1-4 Data cable motor left, black / red 0.5 mm2
K1-5 Data cable motor right, black 0.5 mm2
K1-6 Data cable motor right, black / red
0.5 mm2
K1-7 n. c.
K1-8 n. c.
K1-9 n. c.
K1-10 n. c.
Diagnostic interface (E)
J 1 Diagnostic interface

Connecting the drive motors

The data and motor cables must be routed together in such a
way that they cannot be torn off or damaged.
The cables may be shortened. Please pay attention to
B
different ring eyelet sizes.
Release the cover of the control unit by applying lateral press-
ure to the latching lugs, and clamp the cables as shown in
the connecting diagram (red = positive, black = negative).
Please ensure that the connections are made properly. (Torque
M5 = 3.5 Nm / M6 = 6.0 Nm)

Connecting the battery

Liquid electrolyte batteries must be installed in a separate
box with ventilation leading to the outside. The fuse in the
positive lead must be connected outside the box. A separate
box is not required for gel or AGM batteries. Pay attention to
the battery manufacturer's installation instructions.
The outgoing lines from the terminals must be routed with a
gap between them until after the fuse in the positive lead.
-
Figure 32
+ -
+