Fitting The Drive Elements - Truma Mover XT Instructions De Montage

Mover XT, XT2
Driving direction
Figure 19
Adapting the mud guards to the Mover
1. Remove the mud guards.
2. Fit Mover in accordance with the following installation
instructions.
3. Determine dimensions a and b and transfer to mud guards.
The top leg of the fastening bracket must face towards the
rear of the caravan.
Determining the cut-out sizes
Mover XT, XT2
a
b
Figure 20
Cut out the template on the last page of the installation in-
structions, place it onto the mud guard, transfer the contours
and cut out.
Pay attention to left and right sides!
If necessary, make recesses in mud guard for apron contour
and attach mud guard to underside of caravan 300 mm from
tyre.

Fitting the drive elements

The frame of the vehicle must be free of rust, grease and
heavy soiling. There must be no damage in the area of the
wheel suspension.
The wheels and tyres fitted on the caravan must be of the
same size and type, and must be inflated in accordance with
manufacturer's instructions.
Remove all components from packing and place on the floor.
Figure 21
EN
26
max.
300 mm
Mover
max. 200 mm
a
Mover Mover XT / XT2 XT / XT T T2
b
In order to guarantee the validity of the general oper-
ating permit (ABE), the type plates (f) must be present
on the cross-strut on the right and left.
Figure 22
Mark connection pipe in the centre. Loosely attach the drive
assemblies to the connection pipe.
Do not screw in the supplied threaded bolts (g) yet.
Figure 23
Place the drive assemblies with the connection pipe and
mounting kit (b) on the vehicle frame and bolt them on with
the two bolts (c) in such a way that it is just possible to move
them along the frame.
The gripper (a) must be lying flat against the chassis
frame (e) in its entirety and also flat against the leg (d).
Figure 24
b
Figure 25
f
g
d
e
c
a
b