Ride+ Easy Ii Controller - Trek RIDE+ Pro Manuel Du Propriétaire

RIDE+ EASY II Controller - Quick start
1.4 RIDE+ EASY II Controller
• Switching system On / Off
To switch the system on, push the 'Side' button once. To switch it
off, push the 'Side' button again. After switching on, the bike is
always in cycle mode (zero assist). To prevent loss of riding
information, please make sure that the system is switched off
before the controller is removed from the bike.
Notice: It is strongly advised to ride away in a straight line when an assistance level is selected.
Never select assistance level 3 or 4 during maneuvering or riding away in a tight corner. The powerful
reaction of motor might take you unawares.
• Assistance /(Regeneration) Level
Push '+' button once for assistance level 1, again for higher levels.
Push '-' button to go to a lower level. Regeneration levels are not
installed as standard on the controller.
• Switching lights On /Off
Press the 'Side' button for 2 seconds to switch On / Off the
Controller display light, and if present, the front and rear lights.
Once activated, the light symbol will appear on the screen.
• See total distance/ trip distance
-
Push ' ' button for 5 seconds to switch between total distance and
trip distance.
9