Ride+ Easy Controller - Trek RIDE+ Pro Manuel Du Propriétaire

Quick start - RIDE+ EASY Controller
1.3 RIDE+ EASY Controller
• Switching system On / Off
To switch the system on, push the 'Side' button once.
To switch it off, push the 'Side' button again.
After switching on, the bike is always in cycle mode (zero assist).
Notice: It is strongly advised to ride away in a straight line
when an assistance level is selected. Never select assistance level 3
or 4 during maneuvering or riding away in a tight corner. The powerful reaction of motor might take
you unawares.
• Assistance Level/(Regeneration) Level
For assistance level 1, push the '+ (right hand)' button once.
Push it again for higher levels.Push the '- (left hand)' button to go
to a lower level. Regeneration levels are not installed as standard on
the controller.
• Switching Lights On / Off
Press the 'Side' button for 2 seconds to switch On / Off the
Controller display light, and if present, the front and rear lights.
Once activated, the light symbol will appear on the screen.
8