Wiring According To Emc (Ce−Typical Drive System) - Lenze E82MV Série Instructions De Montage

4 Mechanical installation
Motor mounting
Wiring according to EMC (CE−typical drive system)
4.3.4 Wiring according to EMC (CE−typical drive system)
Conditions for trouble−free operation:
Except for the mains cable, use shielded cables only.
ƒ
The shield must be carefully connected to PE (see below).
ƒ
Connect motor and mains PE conductors to separate PE terminals.
ƒ
A B
X1
G
D
X2
F F
0
Relay connecting cable
1
Mains cables L1, L2, L3, PE (loop through 2 cables to the
mains)
2
PE connection for mains cables
3
Shielded control cables; fix the shield tightly to the sheet
with the cable tie
4
PE connection of motor cable
5
Shielded control cables
6
Isolated terminal (e.g. star point for star connected
motor)
7
FIF support
8
Bus−I/O function module in slot 1
9
Fieldbus function module in slot 2
90
Shield connection:
1. Prepare the cable
B
2. Insert the cable tie
C
3. Lay the cable into
the cable tie and
tighten it. The
shield must be
E
tightly connected
to the shield
sheet.
F
82mot39
l
X1 Terminal strip mains connection
X2 Terminal strip motor connection
PES HF−shield termination by large surface connection to PE
J
H
I
82mot39
EDK82MV752 DE/EN/FR 7.2