Lenze E82MV Série Instructions De Montage page 69

Transport, storage
Transport and storage in a dry, low−vibration environment without aggressive
ƒ
atmosphere; preferably in the packaging provided by the manufacturer.
– Protect against dust and impacts.
– Observe climatic conditions according to the technical data.
Mechanical installation
Install the product according to the regulations of the corresponding
ƒ
documentation. In particular observe the section "Operating conditions" in the
chapter "Technical data".
Provide for careful handling and avoid mechanical overload. During handling neither
ƒ
bend components, nor change the insulation distances.
The product contains electrostatic sensitive devices which can easily be damaged by
ƒ
short circuit or static discharge (ESD). Thus, electronic components and contacts
must not be touched unless ESD measures are taken beforehand.
Electrical installation
Carry out the electrical installation according to the relevant regulations (e. g. cable
ƒ
cross−sections, fusing, connection to the PE conductor). Additional notes are
included in the documentation.
When working on live products, observe the applicable national regulations for the
ƒ
prevention of accidents (e.g. BGV 3).
The Instructions contain notes concerning wiring according to EMC regulations
ƒ
(shielding, earthing, filters and cable routing). The compliance with limit values
required by the EMC legislation is the responsibility of the manufacturer of the
machine or system.
Warning: Controllers are products which can be installed in drive systems of category
C3 according to EN 61800−3. These products can cause interferences in residential
premises. If controllers are used in residential premises, corresponding measures are
required.
Only plug in or remove pluggable terminals in the deenergised state!
ƒ
Commissioning
If required, you have to equip the system with additional monitoring and protective
ƒ
devices in accordance with the respective valid safety regulations (e. g. law on
technical equipment, regulations for the prevention of accidents).
Before commissioning remove transport locking devices and keep them for later
ƒ
transports.
Operation
Keep all protective covers and doors closed during operation.
ƒ
EDK82MV752 DE/EN/FR 7.2
Safety instructions
General safety information
l
2
69