Wiring According To Emc (Ce−Typical Drive System) - Lenze E82MV Série Instructions De Montage

4.2.4 Wiring according to EMC (CE−typical drive system)
Conditions for trouble−free operation:
Except for the mains cable, use shielded cables only.
ƒ
The shield must be carefully connected to PE (see below).
ƒ
Separate control and mains cables from motor cable!
ƒ
Connect motor and mains PE conductors to separate PE terminals.
ƒ
A B
X1
H
D
X2
F F
0
Relay connecting cable
1
Mains cables L1, L2, L3, PE (2 cables for loop−through
connection)
2
PE connection for mains cables
3
Shielded control cables; fix the shield tightly to the
sheet with the cable tie
4
PE connection of motor cable
5
Shielded control cables
6
Motor cable U, V, W (use low−capacitance motor cables!
^ 26)
7
Isolated terminal (e.g. star point for star connected
motor)
8
FIF support
9
Bus−I/O function module in slot 1
:
Fieldbus function module in slot 2
EDK82MV752 DE/EN/FR 7.2
Wiring according to EMC (CE−typical drive system)
Shield connection:
1. Prepare the cable
B
2. Insert the cable tie
C
3. Lay the cable into
the cable tie and
tighten it. The
E
shield must be
tightly connected
to the shield
sheet.
F G
82mot398
l
Mechanical installation
Wall mounting
X1 Terminal strip mains connection
X2 Terminal strip motor connection
PES HF−shield termination by large surface connection to PE
4
K
I
J
82mot397
85