Transportation And Storage - Ryobi RLT26CDS Manuel D'utilisation

WARNING
Injuries may be caused or aggravated by prolonged
use of the product. When using any tool for prolonged
periods, ensure you take regular breaks.

TRANSPORTATION AND STORAGE

■ Stop the engine and allow it to cool before storing or
transporting.
■ Clean all foreign material from the product.
■ Drain all fuel from the tank into a container approved
for petrol. Remember to properly replace and tighten
the fuel cap.
■ Run the engine until it stops. This will remove all fuel
that could become stale and leave varnish and gum in
the fuel system.
■ Store the product in a cool, dry, and well-ventilated
place that is inaccessible to children and well away
from sources of ignition.
■ Keep away from corrosive agents such as garden
chemicals and de-icing salts.
■ Do not store outdoors.
■ When transporting the product in a vehicle, secure
it against movement or falling to prevent injury to
persons or damage to the product.
■ Never carry or transport the product while the engine
is running.
■ Abide all government and local regulations for the
safety storage and handling of petrol.
Short term storage (less than 1 month)
■ Stop the engine, and allow it to cool before storing.
■ Store the product in a cool, dry, and well-ventilated
place that is inaccessible to children and well away
from sources of ignition.
■ Keep away from corrosive agents such as garden
chemicals and de-icing salts.
■ Do not store outdoors.
English (Original instructions)
MAINTENANCE
Servicing requires extreme care and knowledge
and should be performed only be a qualifi ed service
technician. For service we suggest you return the
product to your nearest authorised service centre for
repair. When servicing, use only identical replacement
parts.
Do not, at any times, let brake fl uids, solvents, gasoline,
petroleum-based products, penetrating lubricant, etc.,
to come in contact with plastic parts. Chemicals can
damage, weaken, or destroy plastic which may result in
serious personal injury.
Do not attempt to modify this product or create
accessories not recommended for use with this product.
Any such alteration or modifi cation is misuse and could
result in a hazardous condition leading to possible
serious personal injury.
■ You may make adjustments and repairs described in
■ Consequences
■ After each use, clean the body and handles of the
■ Check all nuts, bolts, and screws at frequent intervals
LINE REPLACEMENT
See fi gure 10.
■ Ensure the unit is in the off position.
■ Remove the spark plug lead to prevent accidental
■ Use a 2.4 mm diameter monofilament string.
■ Cut one piece of string approximately 6m in length.
■ Rotate the knob on the bump head until the line on the
18
WARNING
WARNING
WARNING
this manual. For other repairs, contact the authorised
service centre.
of improper
include excess carbon deposits resulting in loss of
performance and discharge of black lubricant residue
dripping from the silencer.
product with a soft, dry cloth.
for proper tightness to ensure the product is in safe
working condition. Any part that is damaged should be
properly repaired or replaced by an authorised service
centre.
starting.
maintenance may