Ingeteam INGECON SUN STORAGE 1Play Manuel D'installation page 40

Ingeteam
1. Loosen the corresponding packing gland (see Section "2.7. Description of cable inlets"), remove the cap
and pass the cable through it.
2. Connect the wiring to terminal J76 CAN IN as shown in the previous figure, respecting the printed
instructions on the screen-printed electronic card (H: high, L: low, GND: GND). Correctly tighten the
packing glands to prevent losses to the protection class, verifying that the wiring is not taut. Check that
the connection is tight.
40
Connection of the CAN communication for Li-Ion batteries with BMS
ABH2013IQM01_C- Installation and Operation Manual