Medela Magic InBra Rental Mode D'emploi page 9

4. Getting started
Before first use, it is important you do the following to ensure optimal performance of the
breast pump and safety for you and your baby:
-
Charge the breast pump - chapter 5.
-
Disassemble the Accessory set - chapter 6.
-
Clean the motor unit by wiping - chapter 7.
-
Wash and boil the parts (except for the motor unit) - chapter 7.
-
Assemble the breast pump - chapter 8.
5. Charging the breast pump
1. Charge the breast pump for one hour prior to first use.
2. When fully charged, disconnect the power cable and close the charging port.
Two short vibrations and battery status indicator flashing red: Minimum charge level
reached. The breast pump will pause automatically. Finish the pumping session and charge
the breast pump afterwards.
NOTICE
• Never charge the breast pump with a damaged USB power cable.
• Do not charge the breast pump with the milk in the container.
• Do not charge the breast pump while wearing the device in bra.
• Make sure the voltage of the power adaptor is compatible with the power source.
See chapter 21 for technical specifications.
Information
• The breast pump cannot be turned on or operated when connected to the charger.
• Charging is also possible when the breast pump is assembled.
When the power cable is plugged in:
Flashing green; the breast pump is charging
Solid green; the breast pump is fully charged
When the power cable is not plugged in and the breast pump is
switched on:
Solid green; the breast pump is charged (enough charge for
approximately 150 minutes)
Solid yellow; charging after one/current pumping session
advised (approximately 30 minutes left)
Solid red; charge the battery immediately
9