Medela Magic InBra Rental Mode D'emploi page 36

20. International regulations
20.1 Electromagnetic compatibility (EMC)
The Magic InBra™ Rental breast pump complies with all requirements of the relevant
standards and regulations with regard to electromagnetic emission and immunity to
36
interference.
The essential performance functions include vacuum not exceeding 350 mmHg and
backflow protection to prevent milk leakage into the motor unit. The Magic InBra™ breast
pump was tested for immunity to electromagnetic disturbances and passed using the criteria
of maximum vacuum, backflow protection and operation of the breast pump.
• Use of this equipment adjacent to or stacked with other equipment should be avoided
because it could result in improper operation. If such use is necessary, this equipment
and the other equipment should be observed to verify that they are operating normally.
• Portable wireless communications equipment such as wireless home network devices,
mobile phones, cordless telephones and their base stations, walkie-talkies, RFID,
other electrical equipment and also including peripherals such as antenna cables and
external antennas can affect the electric breast pump and should be kept at a distance
of at least 30 cm away from the breast pump including cables. Otherwise, degradation
of the performance of this equipment could result.
• Use of USB cables other than those provided by the manufacturer of this device could
result in increased electromagnetic emissions or decreased electromagnetic immunity
of this equipment and result in improper operation.
Guidance and manufacturer's declaration – electromagnetic emissions
This breast pump is intended for use in the electromagnetic environment specified below.
The customer or the user of the breast pump should assure that it is used in such an environment.
Emission tests
RF Emissions
CISPR 11
RF emissions
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
WARNING
Compliance
Group 1
Class B
Not applicable
Not applicable
Electromagnetic environment – guidance
The breast pump uses RF energy only for its
internal function. Therefore, its RF emissions
are very low and are not likely to cause any
interference in nearby electronic equipment.
The breast pump is suitable for use in
all establishments, including domestic
establishments and thwwose directly
connected to the public low-voltage power
supply network that supplies buildings used
for domestic purposes.