Medela Magic InBra Rental Mode D'emploi page 13

7.2 Washing and disinfecting your Accessory set
Washing and disinfecting are two different activities. They must be done separately to
protect you and your baby, and to maintain the performance of your breast pump.
Wash (before first use and after each use)
– to clean the parts by physically removing
milk residues and other possible contaminants.
1 2
1. Rinse the disassembled parts, except for the
motor unit, with cold water (approx. 20 °C).
2. Wash the parts thoroughly with plenty of warm,
soapy water (approx. 30 °C). Use a mild dish soap.
3. Rinse the parts with cold water for 10 to 15
seconds (approx. 20 °C).
1
1. Wash in dishwasher. Plac
the cutlery section in an orientation that prevents
the parts from collecting water. Use a commercial-
ly available detergent.
2. Rinse the soft silicone parts (the yellow mem-
brane, the grey shield valve and the yellow valve)
under running water after dishwashing.
Dry – allow the washed and disinfected parts to completely dry before using or storing them.
3
OR
2
e on the top rack or in
Allow the parts to air-dry on a clean and dry dish
towel or paper towel. It is important that all residual
moisture dries completely.
Disinfect (before first use and once per day
+
after use) – to effectively lower the number of
germs that may be present on the surfaces of
the washed parts.
Boil the washed parts for at least 5 minutes.
Make sure the parts are fully immersed in
water and that they are not in direct contact
with the bottom of the pot.
Disinfect in microwave using Quick
Clean™* bags in accordance with the
instructions on the bags.
* Refer to local website/shops for availability
in your country.
5 min
OR
13