Medela Magic InBra Rental Mode D'emploi page 19

9.2 Realigning the nipple or switching the side
If you need to realign the nipple or switch the side while there is already milk expressed
follow the steps in section 9.3 to confirm all the milk is collected into the container. Empty
the milk from the container before switching the side and starting a new pumping session.
9.3 Finishing your pumping session
Information
The maximum volume of the container is 150ml. To avoid the container overflowing, it is
recommended to finish your pumping session when the milk fill level reaches the max line
on the container (130ml). Please note that up to 20ml will be in the breast shield tunnel
until collected into the container during step 3 and 4.
1.
3.
If you need to realign the nipple or switch the side when milk has
not yet been expressed:
1. Pause the breast pump by pressing the Start/Pause button.
2. Break the latch with your fingers.
3. Switch the side (if needed) and press the Left selection button or
the Right selection button accordingly.
4. Realign the breast pump on your breast.
5. Resume pumping by pressing the Start/Pause button again.
For finishing, first
press the Start/
Pause button .
A slight vacuum
remains to prevent
leakage.
Hold the pump as
shown in the image
while removing it
from your breast.
There will be milk
in the breast shield
tunnel.
2.
4.
Place the pump on a
flat surface in a hori-
zontal position for a
few seconds. The tunnel
light will flash and the
remaining milk from the
breast shield tunnel will
drain into the container.
The pump will switch
off automatically.
Unclip your bra
supporting the pump
against your breast.
Lean forward and
break the latch with
your fingers to gently
release your nipple
from the pump.
19