Peg-Perego Primo Viaggio All In One Mode D'emploi page 63

Securing the child in the booster seat
Buckle the belt (c - click). Pull on lap belt first (d)
toward the buckle and then on the shoulder belt (e)
making sure that they are not tangled anywhere.
Picture shows the correct belt pattern around the child's
neck and shoulder. Make sure that the belt passes at or
c
e
above shoulder level. The headrest is properly set when
the shoulder belt router is located at no more than 2,5
d
cm (1") above shoulder level and the shoulder lies at the
center of child's chest.
If allowed by your vehicle manufacturer, you may
remove the vehicle head restraint if it prevents you
from achieving a correct installation per the directions
in this manual. Please consult your vehicle manual for
removal and storage of the head restraint.
A gap between the car seat and the vehicle seat back
is acceptable as long as the bottom of the car seat is
flat on the vehicle seat.
2,5 cm
The entire bottom of the restraint must be flat on the
1"
vehicle seat with no overhang.
The seat must be discontinued when the child's
shoulder touches the belt guide, even when the
seat is adjusted at maximum height.
- 63 -