Peg-Perego Primo Viaggio All In One Mode D'emploi page 54

Installing The Child Restraint In A Vehicle
IMPORTANT! ANGLE CHANGE: Check the angle of the backrest. If a change in position is
necessary, remove the tension in the latch strap by pressing on the adjuster button, unlatch
the connector from one side, change the angle to the desired position and re-attach the
connector, making sure to pull it again with maximum tension. If necessary, when recline
the seat in forward facing, pull the rebound bar out in order to create a positive contrast
when tightening the latch strap.
IMPORTANT! TOP TETHER: Always use top tether in forward facing with integrated Harness.
Verify that the child restraint is secure. A secure child restraint will not move more than
1 inch near the seat belt anchors.
- 54 -