Peg-Perego Primo Viaggio All In One Mode D'emploi page 48

Installing The Child Restraint In A Vehicle
IMPORTANT! ANGLE CHANGE: Check the
angle of the backrest. If a change in position
is necessary, change the angle to the desired
position (a) following instruction at page 22,
making sure that the seat clicks in one of the
available position (1to 6).
IMPORTANT! LEG SPACE: If more space is
needed for the occupant, it is possible to
move the rebound bar out (b), following the
procedure at page 17. To do this, unbuckle
the child restraint from the vehicle, move
the rebound bar out and perform a new
installation repeating the procedure above.
Do not leave anti-rebound bar in retracted
position when used in RF mode unless child
weighs less than 15 kg (33 lbs).
IMPORTANT! TOP TETHER STORAGE: When
not in use, keep the tether attached in the
plastic pouch. A free hanging metal hook
could cause injury during a crash.
When installed rear-facing, the car seat does
not touch the vehicle's front seat.
- 48 -