Peg-Perego Primo Viaggio All In One Mode D'emploi page 51

Installing The Child Restraint In A Vehicle
Attach the top tether to the suitable anchor (a - click) in the vehicle following procedure at
page 21. Pull the free end of the strap (b) until it is fully tensioned. A loose tether strap will
reduce the safety of the seat in a crash.
IMPORTANT! ANGLE CHANGE: Check the angle of the backrest. If a change in position is
necessary, remove the tension in the latch strap by pulling the adjuster level (c), unlatch
the connector from one side, change the angle to the desired position and re-attach the
connector, making sure to pull it again with maximum tension. If necessary, when recline
the seat in forward facing, pull the rebound bar out in order to create a positive contrast when
tightening the latch strap.
IMPORTANT! TOP TETHER: Always use
top tether in forward facing mode with
integrated Harness.
IMPORTANT! WEIGHT LIMITS: Combined
weight of the child and the restraint could
exceed designed loads on the vehicle
anchors. Do not install by this method
for a child weighing more than 18 kg (40
pounds).
Verify that the child restraint is secure. A
secure child restraint will not move more
than 1 inch near the seat belt anchors.
- 51 -
b
c
a