Boiling Water - Beem Tea-Switch Mode D'emploi

21
Use
NOTICE
• Only use the device if the lid has been closed correctly and the kettle is placed on the
base station correctly!
• Do not operate the device without water.
If water needs to be added, switch off the device, pull the mains plug out of the socket
and allow the device to cool down for a few minutes.

Boiling Water

1. Pour water into the kettle (8) (see the "Pouring In Water" chapter) and place it on the base
station (5). The display (7) lights up and shows the current water temperature (15).
2. Press the button | (17).
process. In addition, the temperature prevailing in the kettle is shown on the display.
3. As soon as the water has boiled (100°C), you will hear 3 beeps and
on the display. The device switches off.
Keeping Water Warm
1. Pour water into the kettle (8) (see the "Pouring In Water" chapter) and place it on the base
station (5). The display (7) lights up and shows the current water temperature (15).
The display switches off after a few minutes if no button is pressed.
2. Use the buttons + (16) and – (19) to set the desired water temperature at which the water
should be kept warm.
3. Press the PROG button (18). The device switches on automatically.
display.
– As soon as the water has boiled (100 °C), you will hear 3 beeps.
– As soon as the temperature drops 5°C below the selected temperature, the kettle heats up
to this temperature again.
The keep-warm function switches off automatically after 120 minutes. It can be switched
off at any time using the button | (17).
The Temperature Levels
You can select temperatures of between 40 and 100°C with the kettle.
ideal for baby food, for mixing facial masks, oats/porridge
40°C
ideal for milk powder
50°C
ideal for very delicate green tea
60°C
(11) lights up on the display and the device starts the heating
EN
(13) will light up
(12) appears on the