Heating Water - Beem Mr. Tea Mode D'emploi

Mr. Tea
Operating the dispensing tap (11)
Touch mode
Press the lever (12) downwards. The
‹
dispensing tap (11) opens. To close
the dispensing tap again, release the
lever.
Continuous operation
Push the lever (12) fully backwards. It
‹
locks in this position. The dispensing
tap (11) opens. To close the dispens-
ing tap again, push the lever forwards.

Heating water

ATTENTION
► Make sure that the rotary switch (8)
is turned anticlockwise until it stops.
Only then insert the plug into the
mains socket.
22
To heat up water, proceed as follows:
Fill the water tank with the desired
‹
quantity of fresh water. Pay attention
to the maximum level mark (13).
Put the appliance onto the base sta-
‹
tion.
Close the lid of the water tank and
‹
subsequently put the teapot on top
of it.
Turn the rotary switch clockwise until
‹
the desired setting is reached.
The thermostat enables individual setting
of the water temperature, as described in
the section Rotary switch (page 21).
Boiling
If you turn the rotary switch (8) clockwise
until it stops at the
is boiled quickly. If you leave the switch in
this position, the water will continue boiling
until it has completely evaporated.
Intermittent boiling
After the water has boiled, turn the rotary
switch (8) back until the indicator light (10)
extinguishes. This switches the appliance
to intermittent boiling. The appliance then
switches itself on again and starts heating
when the water temperature drops. The
thermostat then controls the power supply
as required and saves energy. The ther-
mostat cycle switches the indicator lamp
(10) on and off.
BEEM - Elements of Lifestyle
EN
position, the water