Beem TEA-SWITCH Mode D'emploi page 22

EN
The base station must always be disconnected from the mains pow-
•
er when it is left unattended and before cleaning it.
Do not make any modifications to the device. Do not replace the
•
connecting cable yourself. If the device, the base station or the
connecting cable are damaged, they must be replaced by the manu-
facturer, customer service department or authorised distributors in
order to avoid any hazards.
It is essential to follow the instructions in the "Cleaning and Care"
•
chapter.
DANGER – Danger of Electric Shock
• Use the device only in closed rooms.
• Do not use the device in rooms with high humidity.
• If the base station
plug out of the plug socket immediately. Only after this should you pull the
out of the water. Before using it again, have it inspected by the manufacturer, customer
service department or authorised distributors in order to avoid any hazards.
• Never touch the base station and the connecting cable with wet hands when the base
station is connected to the mains power.
• Take the kettle off the base station to fill it, pour water or clean it. Make sure that no water
gets into the contacts on the bottom of the kettle.
• Make sure that the steam which emerges does not come into contact with electrical de-
vices and equipment containing electrical components.
WARNING – Danger of Injury
• Keep children and animals away from the packaging material. There is a danger of suffoca-
tion!
Danger of scalding from heat, hot steam or condensation!
• Avoid coming into contact with the rising steam. Do not open the lid of the device
during the boiling and heating process.
• Do not move the device during the boiling and heating process.
• Pour out boiling water slowly and carefully without tipping the device too quickly.
• Make sure that the connecting cable does not present a trip hazard. The connecting cable
should not hang down from the surface on which the device is placed in order to prevent
the device from being pulled down.
falls into water while it is connected to the mains power, pull the mains
18
base station