Beem S9.10.0 Mode D'emploi page 27

29
Operating the Discharge Tap
There are two possible ways of removing the water from the water reservoir (7) using the
discharge tap (12).
Touch Mode (Picture A1)
1. Press down the lever (13) and keep it pressed down. The discharge tap opens and
water fl ows out.
2. Let go of the lever when the quantity of water you want has been removed. The dis-
charge tap closes again.
Constant Mode (Picture A2)
1. Flip the lever all the way back. It locks in place in this position. The discharge tap
opens and water fl ows out.
2. Let go of the lever again and tip it forwards (do not press it down) when the quantity of
water you want has been removed. The discharge tap closes again.
Preparation
NOTE
• Do not operate the device without water. If this does happen, the heating ele-
ment of the device switches off automatically (protection against running dry).
The dry-running protection control lamp
device to cool down for around 5 – 10 minutes before water is poured in and
the device is used again.
If water needs to be added, switch off the device, pull the mains plug out of the
plug socket and allow the device to cool down for a few minutes. When opening the
lid (4), use potholders or similar gloves and be careful.
Boiling Water
1. Pour water into the water reservoir (7) (see the "Operation" chapter | "Filling the Water
Reservoir").
2. Turn the thermostat control (9) clockwise to the position
and start boiling the water. The heating control lamp
carries on boiling until it has completely evaporated.
Heating Water
If water is just to be heated, boil the water once (see the "Preparation" chapter | "Boiling
Water"). As soon as it boils, use the thermostat control (9) to select the setting you want.
The thermostat enables individual, infi nite setting of the water temperature.
lights up. In this case, allow the
to switch on the device
(11) lights up. The water
EN