Mounting The Loop Handle; Mounting The Deflector - Stihl FS 38 Notice D'emploi

English

Mounting the Loop Handle

1
5
50 mm
(2")
2
4
A
Mounting the Loop Handle
: Fit the loop handle (1) on the drive
tube approx. 15 cm (6") (A) forward
of the control handle (2).
: Place the clamp (3) against the
drive tube and push it into the loop
handle.
: Place the square nut (4) in the loop
handle and insert the screw (5) from
the other side and tighten down
firmly.
16
Adjusting loop handle to most
comfortable position:
: Loosen the screw (5).
: Move the loop handle along drive
tube as required.
: Retighten the screw.
3

Mounting the Deflector

2
1
4
: Push the deflector (1) over the
clamp (2).
: Insert nut (3) in the hex recess in the
deflector.
: Make sure the holes line up.
: Fit screw (4) and tighten it down
firmly.
3
FS 38