Adjusting Nylon Line - Stihl FS 38 Notice D'emploi

Blocking the shaft
: Block the shaft by pushing the stop
pin (12) through the holes (13) in the
deflector and thrust plate – turn the
thrust plate back and forth if
necessary.
: Tighten down the mowing head
firmly.
Remove the tool used to block the
shaft.
FS 38
5
4
3
1
STIHL FixCut 5-2
: Fit the thrust plate (2) on the shaft.
: Place the mowing head on the
thrust plate (2).
Collar (arrow) must locate in the
mowing head's mounting hole.
: Push the thrust washer (3) over the
shaft (1) so that it locates against
the base.
: Block the output shaft.
: Use the combination wrench (5) to
screw the mounting nut (4)
counterclockwise onto the output
shaft and it tighten down firmly.
Remove the tool used to block the
shaft.
1
2

Adjusting Nylon Line

STIHK AutoCut
: old the rotating cutting head
horizontal to the ground – tap it on
the ground – about 1 1/4" (3 cm)
fresh line is advanced.
: The blade (1) on the deflector (2)
trims surplus line to the correct
length. Avoid tapping the head more
than once.
Line feed operates only if both lines
still have a minimum length of 1"
(2.5 cm).
English
2
19