Stihl FS 38 Notice D'emploi page 19

Masquer les pouces Voir aussi pour FS 38:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

English
8
2
7
5
6
STIHL AutoCut 5-2
:
Push the mowing head (2) over the
shaft (5) and engage the hex recess
(7) on the external hexagon (6).
:
Place the cap (8) on the head –
turn it clockwise as far as stop and
then tighten it down firmly.
18
8
2
9
STIHL AutoCut C 5-2
:
Push the mowing head (2) over the
shaft – as with the AutoCut 5-2.
:
Screw the spool (9) into the head
until the two arrow points are in
alignment (see illustration) – secure
the spool in this position.
:
Push the cap (8) into the spool as
far as stop, turning it clockwise at
the same time.
:
Turn cap as far as stop and tighten
it down by hand.
10
11
5
STIHL Polycut 6-3
:
Fit the thrust plate on the shaft.
:
Insert mounting nut (10) in the
mowing head.
:
Screw mowing head (11) clockwise
onto the shaft (5) as far as stop.
:
Block the output shaft with the stop
pin.
:
Tighten down the mowing head.
Remove the tool used to block the
shaft.
FS 38

Publicité

Chapitres

Table des Matières
loading

Table des Matières