Led On Charger; Adjusting The Cutter Bar - Stihl HLA 65 Notice D'emploi

English
3)
Electromagnetic problem or fault.
Take the battery out of the machine
tool and refit it. Switch on the
machine – if the LEDs continue to
flash, the battery is faulty and must
be replaced.
4)
Electromagnetic problem or fault.
Take the battery out of the
machine. Use a blunt tool to
remove dirt from the contacts in the
battery compartment. Refit the
battery. Switch on the machine – if
the light emitting diodes still flash,
the machine is faulty and must be
checked by a servicing dealer –
STIHL recommends an authorized
STIHL servicing dealer.
14

LED on Charger

1
The LED (1) on the charger may glow
continuously green or flash red.
Green continuous light ...
... indicates the following:
The battery
is being charged
–
is too hot and must cool down
–
before charging
See also "LEDs on battery".
The green LED on the charger goes off
as soon as the battery is fully charged.
Red flashing light ...
... may indicate the following:
No electrical contact between
–
battery and charger – remove and
refit the battery
Malfunction in battery – see also
–
"LEDs on Battery".
Malfunction in charger – have
–
checked by a servicing dealer.
STIHL recommends an authorized
STIHL servicing dealer.

Adjusting the Cutter Bar

Angle Adjuster - 115°
The angle of th cutter bar can be
adjusted upwards in 2 stages from 0°
(straight) to 45°, and downwards in 3
stages from 0° to 70°. There are
therefore 6 possible working positions.
There is also a special transport position
for the cutter bar – see section on
"Transport Position".
WARNING
To reduce the risk of injury, make
adjustment only with cutting blades at a
standstill – machine switched off,
retaining latch set to ƒ.
HLA 65, HLA 85