Throttle Cable Adjustment; Mounting The Loop Handle - Stihl FS 130 Notice D'emploi

English
15
16
16
15
16
Fitting the Throttle Cable
Do not kink the throttle cable or lay
it in tight radii – make sure the
throttle trigger moves freely.
: Press the throttle cable (15) into the
retainers (16).

Throttle Cable Adjustment

On control handles with slide:
: Go to chapter"Adjusting the Throttle
Cable".
22
7
3
Swiveling the Handlebar
Transport position:
: Release the wing screw (3) and
unscrew it until the handlebar (7)
can be turned clockwise.
: Turn the handlebar 90° and then
swing the handles down.
: Tighten down the wing screw firmly.
Working position:
: Reverse the sequence described
above to swing the handles up
and turn the handlebar counter-
clockwise.

Mounting the Loop Handle

2
90°
Loop handle with barrier bar
: Insert square nuts (1) in the barrier
bar (2).
: Line up the holes.
1
1
FS 130, FS 130 R