Stihl FS 130 Notice D'emploi page 12

!
Warning!
Before cutting, inspect the
area for stones, glass,
pieces of metal, trash or
other solid objects. The
cutting attachment could
throw objects of this kind.
!
Warning!
When using rigid blades, avoid cutting
close to fences, sides of buildings, tree
trunks, stones or other such objects that
could cause the brushcutter to kick out
or could cause damage to the blade.
STIHL recommends use of the nylon line
heads or PolyCut head for such jobs. In
addition, be alert to an increased
possibility of ricochets in such situations.
!
Warning!
This brushcutter is normally to be used
at ground level with the cutting attach-
ment parallel to the ground. Use of a
brushcutter above ground level or with
the cutting attachment perpendicular to
the ground may increase the risk of
injury, since the cutting attachment is
more fully exposed and the brushcutter
may be more difficult to control. Never
use your brushcutter as a hedge
trimmer.
FS 130, FS 130 R
Do not operate using the starting throttle
lock as you do not have control of the
engine speed. See section of your
owner's manual on the proper use of the
slide control.
If the cutting tool or deflector becomes
clogged or stuck, always turn off the
engine and make sure the cutting tool
has stopped before cleaning. Grass,
weeds, etc. should be cleaned off the
cutting tool at regular intervals.
!
Warning!
During cutting, check the tightness and
the condition of the cutting tool at regular
intervals. If the behavior of the tool
changes, stop the engine immediately,
and check the nut securing the tool for
tightness and the cutting tool for cracks
and damage. Replace cracked, bent,
warped, damaged or dull cutting tools
immediately. Such tools may shatter at
high speed and cause serious or fatal
injury.
!
Warning!
A loose blade may cause the blade to
vibrate, crack, break or come off the
brushcutter, which may result in serious
or fatal injury. Make sure that the blade
is properly tightened. Use the wrench
supplied or one of sufficient length to
obtain the proper torque. If the blade
loosens after being properly tightened,
stop work immediately. The retaining nut
may be worn or damaged and should be
replaced. Never use unauthorized parts
to secure the blade. If the blade
continues to loosen, see your STIHL
dealer. Never use a brushcutter with a
loose blade.
Do not attach any blade to a unit without
proper installation of all required parts.
Never use unauthorized parts to secure
the blade. Failure to use the proper parts
may cause the blade to fly off and
seriously injure the operator or
bystanders.
English
11