Mounting The Loop Handle; Adjusting Trimmer For User; Adjusting Length Of Shaft - Stihl FSA 56 Notice D'emploi

8 Adjusting Trimmer for User

1
2
3
► Thread the ends of the nylon lines (4) from the spool (2)
through the openings (1) in the mowing head (5).
► Insert the spool (2) in the mowing head (5).
► Fit the cover (7) on the mowing head (5) so that its tabs
(3) line up with the openings (6) in the mowing head (4).
► Push the cover (7) onto the mowing head (5) as far as
stop.
The tabs (3) engage audibly.
7.2.2 Removing the Spool
► Switch off the trimmer and remove the battery.
1 1
► Press in the tabs (1) and remove the cover (3).
► Remove the spool (2).
7.3

Mounting the Loop Handle

► Switch off the trimmer and remove the battery.
0458-713-9621-B
4
5
6
7
2
3
2
1
► Line up the loop handle (2) so that the recess for the star
knob nut (1) is on the right of the control handle and the
openings in the loop handle (2) are facing the operator.
► Ease the ends of the loop handle (2) apart and push it onto
the control handle until it engages in position.
► Insert the screw (3) through the hole.
► Fit the star knob nut (1) and tighten it down.
The loop handle (2) must not be removed again.
8 Adjusting Trimmer for User
8.1

Adjusting Length of Shaft

The length of the shaft can be adjusted to suit the height and
reach of the user.
► Switch off the trimmer and remove the battery.
► Hold the shaft firmly.
English
3
43