VEVOR C3A18 Pro Mode D'emploi page 15

vigostick.local can still be opened to enter the web management interface. You can open About page of the controller to check the IP
address.
Network status: There is a dot in the upper left corner of the main page. The RED dot indicates that VIGO-STK**** hotspot is active,
and the GREEN dot indicates that the controller has connected to Local WiFi.
The web management interface is as previous page. The web pages functions as follows:
Click the menu "Control", the MOVE Control interface appears, you can click the corresponding button to control the CNC machine
movement.
Click the menu "File", shows the carving files currently stored in the SD card of the current offline controller. You can upload new files
to the controller. After selecting the corresponding carving file to start the carving, the interface displays the file being carved and the
carving progress. You can click the button to pause or stop the carving process.
Click the menu "Settings", enter the carving machine setting interface, where you can set some control parameters, or perform reset,
unlock, restore settings, tools setting, turn on/off laser mode and other commands.
6.7 Laser Engraving App
The offline controller support mobile laser engraving App (For Android and iOS). Before using the App,
please turn on the laser mode in settings of the controller. Turn off the laser mode when you use CNC tools.
Please get the VevorWorks App form our website www.VevorEngraver.com ,or scan the right QR-code to
download.
App supports Android and IOS. It can import mobile phone pictures, take photos with mobile camera, edit
graphics and text, generate engraving content, support gray, black and white, contour and other engraving
modes, and control engraving in real time.
7. FA
Q: How to use the lasers
A: 1. For XTS05/XTS08/XTS10/XTS15 laser, please place the material flat under the laser, and make the distance between them within
3~10cm (Less distance will not be able to focus). Turn on the weak light, then there will be a light spot on the material, just turn around
the focus ring on laser to adjust the spot become smallest and clearest, which means the best focus.
2. XTS15D laser is fixed focus laser which is not adjustable. The fixed focal Length is 18mm. Please use the focusing column to
determine the distance from the engraved object to the top surface of copper ring of light outlet.
Q: Laser module can't burn anything, no light, weak power.
A: 1. Please check power, speed setting on software and adjust focus length for laser [refer to 3.2 above to adjust focus].
Q: The picture engraved is the opposite of the original picture
A: Just need to adjust on software [ Reversal X/Y axis]
Q: The picture engraved distortion.
A: The screw rod and motor shaft are not locked and slipping.
-14-