Preparing The Connection To The Flue - Dovre VINTAGE 35GA Installation Et Mode D'emploi

Positioning the restriction plate serves to
adjust the draft in the stove to the duct route
selected.
The restriction plate can be placed in three pos-
itions, marked with 1, 2 and 3; see next figure. If
you decided on a permitted duct route, the correct
position for the restriction plate follows from the
appendix "Calculation sheet for checking projected
route".
Attach the restriction plate with a screw in the right
position in front of the exhaust to which you con-
nect the stove.
First remove the rear mirror panel in order to
attach and adjust the restriction plate.
Preparing the connection to
the flue
When connecting the stove to the flue, you can
choose to connect to the top or to the back of the
stove.
Connecting to the back
The stove is ready to be connected to the back upon
delivery.
If a pipe system other than that from man-
ufacturer Muelink & Grol is used, always use
the corresponding collars and/or adapters sup-
plied by this other manufacturer.
10
Connecting to the top
1. Unscrew the connection collars (1) and (2) from
09-20020-190
2. Remove the cover plates (3) and (4) at the top of
3. Install the connection collars (1) and (2) on the top
the back of the stove; see next figure.
the stove.
of the stove, check whether the sealing profile
seals completely; see next figure.
If a pipe system other than that from man-
ufacturer Muelink & Grol is used, always use
the corresponding collars and/or adapters sup-
plied by this other manufacturer.
2
1
Subject to change because of technical improvements
3
4
1
2
09-20020-191
3 4
09-20020-192