Dovre VINTAGE 35GA Installation Et Mode D'emploi page 57

2
3
1
3
2 1
Placing the stove
Preferably place the stove on a flat floor. The stove
is equipped with levelling screws in the floor plate
so the appliance can be levelled perfectly; see next
figure.
Subject to change because of technical improvements
09-20020-188
09-20006-010
Take the distance from combustible material into
account. See the appendix "Distance from com-
bustible material".
Determining the duct route
09-20020-189
Make a drawing of the route you want the concentric
exhaust duct to follow.
Check whether the duct route you want is per-
mitted from a technical point of view based on the
appendix "Calculation sheet for checking projected
route". If this is not the case, you must decide on
an alternative route that is within the limits per-
mitted.
Decide on the type and number of the parts
required. Use the appendix "Overview of con-
centric flue gas exhaust materials" for this.
Attaching a restriction plate
Depending on the route selected and the ratio
between vertical and horizontal length, a restriction
plate must be attached to the stove at the right place
and in the right position. The restriction plate is
included separately in the delivery of the appliance.
9