Placing Decorative Wood Block Set - Dovre VINTAGE 35GA Installation Et Mode D'emploi

The code only has to be set once, thus not
when you replace the batteries in the handset
or receiver.
1. Press the receiver's reset button and continue
pressing until you hear two beeps; see next figure.
Release the reset button after the second beep.
The first beep is short and the second is long.
2. Within 20 seconds press the button
flame) on the handset until you hear two additional
short beeps. The code is now set. If you hear a
long beep, this means that programming the code
was not successful, for example because the wir-
ing is incorrect. Check the wiring and try again.
Placing decorative wood
block set
Check whether the burner is in the correct position,
as it could have shifted during transport. The burner
rests loosely on the bottom of the combustion
chamber, supported by the gas pipe holder on the
back and by legs at the left and right front.
The complete wood block set consists of three
blocks of ceramic imitation wood and a bag of ash
granules.
The blocks are fragile, treat them with care.
The blocks must be placed on the burner
exactly as indicated in the photos.
Vintage 35GA
Follow the instructions below to place the blocks:
1. Place the first block at the back on the middle of
the burner plate right in front of the back row of
16
09-20020-216
(small
holes; see following figures.
2. Next place the second block on the burner in the
position indicated; see next figure.
Subject to change because of technical improvements
09-20020-207
09-20020-209