Placing Decorative Wood Block Set - Dovre VIRTUS 50GA Installation Et Mode D'emploi

We recommend that you replace the batteries
l
every two years.
Batteries – receiver.
4 x 1.5 V AA (recommended quality: alkaline).
l
Indicator light battery nearly empty: regular beeps
l
for three seconds when the motor is running.
In place of the batteries, it is possible to use an
l
AC adaptor.
Insert the batteries in the transmitter (handset) and
in the receiver (3) (black box, lid (6) can be opened
easily).
The receiver is situated in the base of the appli-
ance: this is easy to reach by removing the two
knurled screws (1) and letting the cover (2) drop
down; see the following figure.
2 1 3 5
6 7 5
Programming the electronics code
Codes selected from approximately 65,000 randomly
available codes are automatically assigned to all Mer-
tik Maxitrol electronics. This code is assigned to the
handset for the remote control set. The receiver must
read this code from the handset.
The code only has to be set once, thus not
when you replace the batteries in the handset
or receiver.
1. Press the receiver's reset button and continue
pressing until you hear two beeps; see next figure.
D OVRE
14
4
09-20022-041
Release the reset button after the second beep.
The first beep is short and the second is long.
2. Within 20 seconds press the button
flame) on the handset until you hear two additional
short beeps. The code is now set. If you hear a
long beep, this means that programming the code
was not successful, for example because the wir-
ing is incorrect. Check the wiring and try again.
Placing decorative wood
block set
The blocks are fragile, treat them with care.
The blocks must be placed on the burner
exactly as indicated in the photos.
Follow the instructions below to place the blocks:
When positioning the wood block set, make sure that
the pilot flame and the second thermocouple remain
free. Position the components in the way shown in the
following figures.
The wood block set consists of eight ceramic wood
blocks, coals and filament.
1. Position the coals and the filament.
Subject to change because of technical improvements
09-20020-216
(small