Preparing The Connection To The Flue; Closed System Connection - Dovre VIRTUS 50GA Installation Et Mode D'emploi

3 2
Preparing the connection to
the flue
When connecting the stove to the flue, you can
choose to connect to the top or to the back of the
stove.
Connecting to the top
The stove is ready to be connected at the top upon
delivery.
When a pipe system from a manufacturer other
than Muelink & Grol is used, first use the
adapter belonging to that manufacturer's pipe
system.
Connecting to the back
1. Remove the top plate.
2. Remove the heat shield (A) and break out the
cover.
Subject to change because of technical improvements
3. Remove cover plate (B) and its seal (3) on the
1
4. Remove cover plate (C) and its seal (3) on the
5. Remove the outer collar (1) and its seal (3) at the
6. Remove the inner collar (2) and its seal (3).
7. Fit the inner collar (2) and the outer collar (3) with
8. Fit the cover plates (B) and (C) and their respect-
09-20022-046
9. Replace the heat shield (A).
10. Fit the top plate.

Closed system connection

The concentric exhaust system allows for a series of
connection options for this appliance:
First place the stove, see section "General pre-
09-20022-052
paration". The concentric duct system can then be put
together in steps, starting at the stove.
back.
back internally.
top.
their respective seals (3) to the back of the appli-
ance.
ive seals (3) to the top of the appliance.
4 1
3
2
3
4
Through the facade, at any height, with or without
horizontal or oblique joint.
Through the roof, with or without horizontal or
oblique joint.
Through an existing flue gas exhaust pipe (chim-
ney)
PH2
A
C 3 B
09-20022-049
D OVRE
9