Preparing The Connection To The Flue - Dovre VINTAGE 35GA Type C11 Mode D'emploi

09-20006-010
Take the distance from combustible material into
account. See the appendix "Distance from com-
bustible material".
Determining the duct route
Make a drawing of the route you want the concentric
exhaust duct to follow.
Check whether the duct route you want is per-
mitted from a technical point of view based on the
appendix "Calculation sheet for checking projected
route". If this is not the case, you must decide on
an alternative route that is within the limits per-
mitted.
Decide on the type and number of the parts requi-
red. Use the appendix "Overview of concentric flue
gas exhaust materials" for this.
Attaching a restriction plate
Depending on the route selected and the ratio bet-
ween vertical and horizontal length, a restriction plate
must be attached to the stove at the right place and in
the right position. The restriction plate is included
separately in the delivery of the appliance.
Subject to change because of technical improvements
Positioning the restriction plate serves to
adjust the draft in the stove to the duct route
selected.
The restriction plate can be placed in three posi-
tions, marked with 1, 2 and 3; see next figure. If
you decided on a permitted duct route, the correct
position for the restriction plate follows from the
appendix "Calculation sheet for checking projected
route".
Attach the restriction plate with a screw in the right
position in front of the exhaust to which you con-
nect the stove.
First remove the rear mirror panel in order to
attach and adjust the restriction plate.
Preparing the connection to
the flue
When connecting the stove to the flue, you can
choose to connect to the top or to the back of the
stove.
Connecting to the back
The stove is ready to be connected to the back upon
delivery.
If a pipe system other than that from manu-
facturer Muelink & Grol is used, always use the
corresponding collars and/or adapters supplied
by the other manufacturer.
09-20020-190
9