Dovre VINTAGE 35GA Type C11 Mode D'emploi page 63

3. Place the third block at the front of the burner, obli-
quely over the second block; see next figure.
4. Spread the ash granules in the front over the visi-
ble surface area of the burner.
Keep the gas exhaust openings and the burner
air holes free of coals as much as possible.
Keep the area around the pilot free to prevent
ignition failure; see following figure.
The flame effect is determined in part by the
way the granules are spread over the burner
surface. In certain cases it may be necessary
to change the distribution of the ash granules
by partially freeing up several burner openings,
for example, in order to improve the flame
effect.
5. Re-position all removed parts in the correct places
in the stove.
Subject to change because of technical improvements
The stove is now ready for use.
Vintage 50GA
Follow the instructions below to place the blocks:
1. Place the first block at the back on the middle of
the burner plate right in front of the back row of
holes; see following figures.
09-20020-210
2. Next place the second block on the burner in the
position indicated; see next figure.
09-20020-211
3. Place the third block at the front of the burner, obli-
quely over the second block; see next figure.
When replacing the glass pane, check that the
sealing profile is in the right place and fits pro-
perly.
09-20020-212
09-20020-213
17