Closed System Connection - Dovre VINTAGE 35GA Type C11 Mode D'emploi

Connecting to the top
1. Unscrew the connection collars (1) and (2) from
the back of the stove; see next figure.
2. Remove the cover plates (3) and (4) at the top of
the stove.
3. Install the connection collars (1) and (2) on the top
of the stove, check whether the sealing profile
seals completely; see next figure.
If a pipe system other than that from manu-
facturer Muelink & Grol is used, always use the
corresponding collars and/or adapters supplied
by the other manufacturer.
10
3
4
1
2
09-20020-191
2
1 3 4
09-20020-192
4. Install the cover plates (3) and (4) to the back of
the stove.
Install the smallest plate first.
5. Unscrew the round cover lid from the top plate.
6. Place the top plate back on the stove before the
connection duct is installed.

Closed system connection

The concentric exhaust system allows for a series of
connection options for this appliance:
Through the facade, at any height, with or without
horizontal or oblique joint.
Through the roof, with or without horizontal or obli-
que joint.
Through an existing flue gas exhaust pipe (chim-
ney)
First place the stove, see section "General pre-
paration". The concentric duct system can then be put
together in steps, starting at the stove.
Structural conditions may make it necessary
for (part of) the concentric duct system to be
built in first.
Facade sleeve through a facade of
non-flammable material
Read the "Installation Conditions" chapter care-
fully and follow the installation instructions
below.
The following illustration shows the situation of a finis-
hed facade sleeve.
Subject to change because of technical improvements