Preparing The Connection To The Flue - Dovre VIRTUS 50GA Installation Et Mode D'emploi

(50 mm). See following figure. If you decided on a
permitted duct route, the correct position for the
restriction plate follows from the appendix "Cal-
culation sheet for checking projected route".
3 2
Preparing the connection to
the flue
When connecting the stove to the flue, you can
choose to connect to the top or to the back of the
stove.
Connecting to the top
The stove is ready to be connected at the top upon
delivery.
When a pipe system from a manufacturer other
than Muelink & Grol is used, first use the
adapter belonging to that manufacturer's pipe
system.
Connecting to the back
1. Remove the top plate.
2. Remove the heat shield (A) and break out the
cover.
Subject to change because of technical improvements
1
3. Remove cover plate (B) and its seal (3) on the
4. Remove cover plate (C) and its seal (3) on the
09-20022-046
5. Remove the outer collar (1) and its seal (3) at the
6. Remove the inner collar (2) and its seal (3).
7. Fit the inner collar (2) and the outer collar (3) with
8. Fit the cover plates (B) and (C) and their respect-
9. Replace the heat shield (A).
10. Fit the top plate.
back.
back internally.
top.
their respective seals (3) to the back of the appli-
ance.
ive seals (3) to the top of the appliance.
4 1
3
2
3
4
09-20022-052
PH2
C 3 A
B
09-20022-049
D OVRE
9