Dovre VIRTUS 50GA Installation Et Mode D'emploi page 60

The flame height modulates between high and low. If
the room temperature is lower than the set tem-
perature, the flame stays high for longer. If the room
temperature is higher than the set temperature, the
flame stays low for longer. One cycle takes approx-
imately 20 minutes.
Thermostatic mode
ON: Press the [Thermostat] button. The symbol is
displayed, the pre-set temperature is briefly displayed,
and then the room temperature
OFF:
1. Press the [Thermostat] button.
2. Press the
or button to switch to Manual
mode
3. Press the [Programme] button to switch to Pro-
gramme mode.
4. Press the [Eco] button to switch to Eco mode.
D OVRE
22
09-20021-384
DEFINING THE SETTINGS:
1. Hold down the [Thermostat] button until the tem-
perature starts blinking.
2. Press
or to set the specified temperature.
3. To confirm, press the [Thermostat] button or
wait.
Subject to change because of technical improvements
09-20021-385