Switching On The Stove - Dovre VIRTUS 50GA Installation Et Mode D'emploi

OFF: To deactivate, press the [on/off] and
at the same time. The symbol for the child safety lock
disappears.

Switching on the stove

Before switching on the appliance, the Manual button
on the GV60 gas valve must be ON and the on/off
switch on the gas valve must be ON
Once the pilot flame is lighting, the motor will
automatically switch to the maximum flame
setting
One-button operation
Press the [on/off] button (one-button ignition) until you
hear two short beeps and you see a blinking series of
lines
This confirms that the initiation sequence has started;
release the button.
The mains gas starts flowing as soon as the
l
pilot flame has been ignited.
The handset automatically switches to Manual
l
mode after the main burner has been ignited.
You can switch from one-button ignition to two-button
ignition by holding down the [on/off] button for longer
than 10 seconds after inserting the batteries. ON
D OVRE
18
buttons
09-20021-374
appears on the display, 1 starts blinking. When the
switch has been made, 2 starts blinking
Two-button operation
Press the [on/off] button and
until you hear two short beeps and you see a blinking
series of lines
This confirms that the initiation sequence has started;
release the button.
The mains gas starts flowing as soon as the
l
pilot flame has been ignited.
The handset automatically switches to Manual
l
mode after the main burner has been ignited.
You can switch from two-button ignition to one-button
ignition by holding down the [on/off] button for longer
than 10 seconds after inserting the batteries. ON
appears on the display, 2 starts blinking. When the
switch has been made, 1 starts blinking
Subject to change because of technical improvements
09-20021-375
(two-button ignition)