Placing Of The Imitation Coal Matrix And Loose Coals; Finishing - Dovre 250DV Installation Et Mode D'emploi

3.5. Placing the imitation coal matrix and loose coals
3.5.1. Positioning of the burner
If it has not yet been done, first remove the package containing the imitation coals
and matrix from the combustion chamber.
Take Care! These parts are fragile. Handle them carefully.
Check that the burner and the mirror plate are correctly
positioned and have not shifted during transport. The burner sits
loose on the bottom of the combustion chamber, supported at the
back by the injector housing, and on the left and right at the front
on two small studs on the left and right side of the combustion
chamber. The back mirror hangs on two studs on the upper left
and right side of the combustion chamber and rests on two other
studs for maintaining the vertical position. See figure for correct
positioning.
3.5.2. Placing the matrix and loose coals
The complete set of imitation coals consists of matrixes pre -assembled) and 11
loose coals.
The parts must be positioned on the burner as shown in the drawings below.
1
3
5 loose coals
3.6.

Finishing

Mount the glass door and secure it with the 2 bolts at the top. Slide the cast iron
front plate from the top between the side panels and slide it down. Cover with the
top plate. Both the front and the top plate remain loose and must not be secured by
any other means.
Light the unit and check to see that it is working satisfactorily.
250DV
2
4
6 loose coals
- 24 -
03.27988.000