Placing Decorative Wood Block Set - Dovre Sense 203GAO Installation Et Mode D'emploi

1. Press the receiver's reset button and continue
pressing until you hear two beeps; see next figure.
Release the reset button after the second beep.
The first beep is short and the second is long.
2. Within 20 seconds press the button
flame) on the handset until you hear two additional
short beeps. The code is now set. If you hear a
long beep, this means that programming the code
was not successful, for example because the wir-
ing is incorrect. Check the wiring and try again.
Placing decorative wood
block set
The blocks are fragile, treat them with care.
The blocks must be placed on the burner
exactly as indicated in the photos.
Follow the instructions below to place the blocks:
When positioning the wood block set, make sure that
the pilot flame is kept free. Position the components in
the way shown in the following figures.
The wood block set consists of 10 ceramic wood
blocks.
10
09-20020-216
(small
1. Distribute the bag of coals over the burner bed;
leave the pilot flame opening free.
2. Position the wood blocks in the sequence dis-
played in the following figures:
Subject to change because of technical improvements
09-20021-395
09-20021-396