Dovre Sense 203GAO Installation Et Mode D'emploi page 65

(continued)
Subject to change because of technical improvements
Problem
Soot deposit on ther-
Clean the thermocouple with a cloth.
mocouple
Thermocouple faulty Replace the thermocouple (*).
No spark
Spark but no ignition
When ignition button is released, pilot flame goes out
Main burner does not ignite
Whistling between high and low setting
Disrupted flame effect
Gas smell
Smell of combustion gases in room
Appliance goes out
Remote control does not work
possible solution
possible cause
(*) = have installer carry out this action
Electromagnetic valve faulty Replace the control block (*).
Blocked pipes or nozzles Blow through the parts and clean them (*).
Burr on nozzle Remove the burr (*).
Clean the burner, check the placement of the logs,
Dirty burner
remove any coal from the burner openings (*).
Close the main valve, find the gas leak and repair the leak
Gas leak
(*).
Blocked smoke exhaust
Check the ducts and clean them (*).
duct or air supply ducts
Appliance is leaking air Check the door seals and appliance joints (*).
Dust on combustion cham-
Clean the combustion chamber.
ber
Empty batteries Replace the batteries.
Wiring to gas block Trace any bad contact point and repair it.
Faulty transmitter or
Replace the remote control.
receiver
31