Establishing A Gas Connection; Installing The Remote Control Set - Dovre Sense 203GAO Installation Et Mode D'emploi

if there is a fire in the fireplace, or otherwise make
sure there is an extra air supply for these appliances.

Establishing a gas connection

The connection to the gas pipe is on the back of the
gas regulator block, which is at the bottom right of the
stove.
The connection must meet the following conditions :
A coloured gas valve must be inserted in the gas
supply pipe, as close to the stove as possible and
always accessible.
The connection must be voltage-free.
Have a certified installer make the connection.
Follow the instructions below:
1. Check whether the type of gas and gas pressure
on site correspond with those marked on the type
plate.
The type plate is located on the appliance.
2. Assemble the gas supply pipe. 3/8" G pipe or cop-
per pipe with diameter 10/12 mm suffices for pipes
up to +/- 10 m. 1/2" G pipe or copper pipe with dia-
meter 13/15 mm is used for lengths exceeding 10
m.
3. Install the gas valve.
4. Connect the stove to the gas supply pipe. The gas
connection can be made using the opening on the
back. Use a 3/8" coupling to do this.
5. Check if the supply pipe is gastight (using soapy
water, for example).
Installing the remote control
set
The Mertik Maxitrol GV60 remote control set consists
of a handset (transmitter) and a receiver. The system
works on batteries; connecting an AC adaptor is
optional.
The batteries (2 x 1.5 Volt AAA for the handset
(transmitter), 4 x 1.5 Volt AA for the receiver)
are included.
Use only the Mertik Maxitrol AC adaptor or an
adaptor preapproved by Mertik Maxitrol. Other
Subject to change because of technical improvements
adapters probably do not suit your system
and/or can damage it.
Batteries – handset (transmitter)
▪ 2x 1.5 Volt AAA (LR 03) (recommended quality:
alkaline).
▪ Handsets with display: Battery indicator on the dis-
play.
▪ We recommend that you replace the battery after 2
years.
Batteries – receiver
▪ 4x1.5 V AA (recommended quality: alkaline)
▪ indicator light Battery nearly empty: beeps regularly
for 3 seconds if the motor is running.
▪ An AC adaptor may have to be used instead of bat-
teries.
Insert the batteries in the transmitter (handset) and
in the receiver (black box, lid can be opened eas-
ily).
The receiver is located on the left in the base of the
appliance, behind the hatch in the base; see the fol-
lowing figure.
Programming the electronics code
Codes selected from approximately 65,000 randomly
available codes are automatically assigned to all Mer-
tik Maxitrol electronics. This code is assigned to the
handset for the remote control set. The receiver must
read this code from the handset.
The code only has to be set once, thus not
when you replace the batteries in the handset
or receiver.
09-20021-414
9