Switch Off Gas To Stove - Dovre Sense 203GAO Installation Et Mode D'emploi

1
2
3
4
1 Piezo ignition
2 On/off switch (option)
3 Eight-wire-receiver-contact
4 Microswitch
5 Piezo ignition connection (2.8x0.8mm)
6 Manual button in MAN position
7 Manual pilot regulator
8 Main valve button in OFF position
Access to the pilot is only required for igniting
with a match.
Do not exert excessive force when turning the
main valve button. The button has a slip-action
clutch that clicks until the final stops are
reached. This enables manual programming of
the flame height and the pilot standby position.
Read the safety information before continuing.
1. Turn the main valve button (8) to the OFF position,
completely clockwise
2. Turn the MANUAL button (6) to the MAN position,
completely clockwise
Subject to change because of technical improvements
5
3. Wait five minutes until the stove is free of gas.
6
7
4. Press the manual pilot regulator (7) all the way in
8
09-20020-244
5. If applicable, put the pilot access panel back in
6. Turn the MANUAL button to the ON position,
7. Turn the MANUAL button to the ON position,
8. If the appliance does not work, follow the instruc-

Switch off gas to stove

If the gas regulator is accessible, turn the main valve
.
button to the OFF position, completely clockwise
.
A manual pilot regulator and Piezo ignition
(option) are accessible when the MAN button
is in the MAN position.
Check by smell whether any gas is still present
around the stove, including near the floor.
If you detect any gas odour, stop immediately.
See the last warning in the chapter "Safety". If
no gas is present, proceed to the next instruc-
tion step.
and continue pressing to start the pilot gas flow.
Ignition with a match:
Ignite the pilot directly with a match while keeping
the manual pilot regulator pressed in for approx-
imately one minute after the pilot is ignited. Then
release the manual pilot valve regulator. If the pilot
goes out, wait for five minutes and repeat the
instruction above.
Piezo ignition:
Move the ignition cable from the receiver to the
valve; see the previous figure. Press the Piezo
ignition. If the pilot goes out, wait for five minutes
and repeat the instruction above.
If the pilot continues to go out after several
attempts, switch the gas regulator button (main
valve button) to OFF and proceed to step (8).
place before continuing.
entirely counter-clockwise
entirely counter-clockwise
tions under "Switch off gas to stove".
.
If the stove will not be used for an extended
period, close the gas valve in the gas supply
pipe as well.
.
23