Declaration Of Conformity; Safety - Dovre VINTAGE 35GA Installation Et Mode D'emploi

Declaration of
conformity
The undersigned
Dovre nv, Nijverheidsstraat 18 B-2381 Weelde,
hereby declares
that Vintage 35GA(P) and Vintage 50GA(P) gas
stoves are manufactured according to the EN 613.
Weelde 01-10-2013
Due to continuous product improvement, the supplied
appliance specifications can vary from the description
in this brochure without prior notice.
DOVRE N.V.
Nijverheidsstraat 18 Tel : +32 (0) 14 65 91 91
B-2381 Weelde Fax : +32 (0) 14 65 90 09
Belgium E-mail : info@dovre.be
4
Notified body: 2013

Safety

Please note: All safety regulations must be
complied with strictly.
Please read carefully the instructions supplied
with the appliance for installation, use and
maintenance before using the appliance.
The appliance must be installed in accordance
with the legislation and requirements applic-
able in your country.
All local regulations and the regulations relating
to national and European standards must be
observed when installing the appliance.
The appliance must be placed, connected,
commissioned and inspected by an authorized
installer, in accordance with the current
national and local standards, in accordance
with regulations for closed appliances and in
accordance with the installation instructions of
the manufacturer.
The appliance is designed for heating pur-
poses. All surfaces, including the glass and
connecting tube, can become very hot (over
100°C)! Make sure there is sufficient protection
if young children, disabled persons or old
people are in the vicinity of the appliance.
Safety distances from flammable materials
must be strictly adhered to.
Do not place any curtains, clothes, laundry or
other combustible materials on or near the appli-
ance. The minimum safe distance is 80 cm.
When in use, do not use flammable or explos-
ive substances in the vicinity of the appliance.
If the glass in the appliance is broken or
cracked, it must be replaced before you can
use the appliance again.
The appliance has been set and sealed in the
factory, in accordance with the category stated
on the model plate and at the correct nominal
load. Check that the information on the model
plate corresponds with the local gas type and
pressure, and with the nature of your install-
ation. The model plate is behind the door at the
Subject to change because of technical improvements