Installing The Remote Control Set - Dovre VINTAGE 35GA Installation Et Mode D'emploi

Installing the remote
control set
The Mertik Maxitrol GV60 remote control set consists
of a handset (transmitter) and a receiver. The system
works on batteries; connecting an AC adaptor is
optional.
The batteries (1 x 9 Volt block for the handset
(transmitter), 4 x 1.5 Volt AA for the receiver)
are not included in the delivery.
Use only the Mertik Maxitrol AC adaptor or an
adaptor preapproved by Mertik Maxitrol. You
may not be able to use the system with other
adaptors.
Batteries – handset (transmitter)
▪ 1x 9 V (recommended quality: alkaline)
▪ Handsets with display: indicator light Battery nearly
empty
▪ Handsets without display: the red LED becomes
darker
▪ We recommend you replace the battery after 2
years.
Batteries – receiver
▪ 4x1.5 V AA (recommended quality: alkaline)
▪ indicator light Battery nearly empty: beeps regularly
for 3 seconds if the motor is running.
▪ An AC adaptor may have to be used instead of bat-
teries.
Insert the batteries in the transmitter (handset) and
in the receiver (black box, lid can be opened eas-
ily).
The receiver (2) is on the back of the stove, under
the protective plate (1); see next figure.
Subject to change because of technical improvements
1 2
See next figure for the complete wiring diagram.
1.
3.
6.
1 Pilot
2 Gas block
3 Thermo-couple circuit breaker
4 Receiver
5 RESET button
6 Ignition cable
7 Thermoelectric cable TC
8 Thermoelectric cable SW
9 Eight-wire cable
Programming the electronics code
Codes selected from approximately 65,000 randomly
available codes are automatically assigned to all Mer-
tik Maxitrol electronics. This code is assigned to the
handset for the remote control set. The receiver must
read this code from the handset.
09-20020-196
9.
2.
8.
7.
4.
5. 09-20020-206
15